Note: Masks created with Intersect With result in Subtract component masks. Then, the component mask is switched from a subtract to an add with Convert to Add. Using a soft brush, paint over the areas you want to make darker with white. The multi-component mask is duplicated and the base component, in this example the Luminance Range mask, is inverted. I want to create a script that will invert/swap the input and output values of all the points in each channel of a selected curves adjustment layer. Press Ctrl/Cmd + I to invert the layer mask. The first mask is a Luminance Range mask affecting the blue tones that is intersected with a gradient removing the treatment from the sky. Right click and choose Convert to Add or Convert to Subtract.Ĭontinue converting the remaining mask components.īelow is an example of part of this sequence using the common “duplicate & invert” editing technique. Invert the base mask (the bottom-most component) The recipe to invert a complex mask in Lightroom is: The good news - you can invert these masks. How do you invert a multi-component mask in Lightroom? The mask may be intersected with another mask, like a range mask or another brush. The mask may start with a gradient, and then subtract or add brush strokes. With Lightroom’s new multi-component masks, a single mask can get complex.

save as: flipped_curve.amp or any name you likeħ. add another adjustment layer/invert on top of the two other adjustment layersĥ. add an adjustment layer/curves and load the curve you want to flipģ. When Photoshop opens the photo, click Image > Adjustments > Invert in the menu bar. Here's how to do it: Launch Photoshop on your computer, and click File > Open. This section covers how to invert the colors of an entire photo in Photoshop. add an adjustment layer/invert to this fileĢ. With Photoshop, you can invert the colors of an entire image or a selected area of an image. To flip a curve you open the basic photoshop raw file described in the curve merging article and do the folowing:ġ. This can be done with the Curve Merging technique and photoshop raw file method described here. For example when you want to build your curve into a QuadTone Rip profile. In both cases you will arrive from A to B but you should never mix the method.Īnyway, sometimes it comes handy to change a ‘use before inverting’ curve into an ‘use after inverting’ curve. It’s like driving left or ride side of the road. There are two ‘schools’ of curving for digital negatives. A correction curve for digital negatives that is meant to be used on a positive image before inverting to a negative should not be confused with a curve that has to be applied to an allready inverted image.

Invert adjustment photoshop